Here are the links to the other post where I decided to do this modification and made other changes:
Ergonomics on the Cheap
Mouse placement
Mounting the Monitor to the Wall
![]() |
| Original desk height - monitor is directly above it |
![]() |
| Not really surgical precision, but my cutting won't be either |
![]() |
| One side marked |
![]() |
| Both sides marked. Ready to go |
![]() |
| Now we're getting somewhere! |
Here is the leg after the initial cut:
![]() |
| Cut complete |
After cutting one leg and part of another, the cutting wheel was worn down to the nub.
I decided to try something that involved a bit less jumping around and scratching the leg (and possibly less burning embers flying around in my garage).
![]() | ||
| Plan B. Cheap and easy (but labor intensive). |
![]() |
| Note the difference in distance between the legs, as compared with the earlier picture |
![]() |
| Bearings at rest means table is level |
![]() |
| Fine tuning |
Here are the final, shorter feet.
And, the complete picture. Note the greater distance between the table and the monitor.
![]() |
| Final configuration - Monitor is same height, but desk is lower |
In the end, this only took me about 2 hours to complete (not counting clearing off my desk). However, the time I spent planning to get this done was over a month.
As for the ergonomics, this height is much better for me. I'm conscious of not bending my wrists now, but having the desk at the right height makes it much easier. I don't know why I put up with using this height for so many years without making these changes.
Update: The short link to this article is http://bit.ly/9zxPJP
















No comments:
Post a Comment