| Before - the projector sat on a cheap standing shelf |
By the way, there's a lot of support over at http://www.avsforum.com for choosing and setting up projectors, as well as selecting or even building your own mounts. Search around there.
I also don't like the look of L-bracket shelves. They look cheap. I was frustrated at the lack of good options, but a co-worker finally convinced me to look into a suspended shelf, and that's exactly what I needed. That also provided the push to actually start this project, which is coincidentally the most important part.
Cost was a factor, but finding a suspended shelf deep enough for the projector was the biggest hurdle. I finally figured it out – buy the cables and the shelf separately. There are lots of options for "cable shelf brackets" but I've ordered from here before (and this was one of the cheapest options) http://www.stacksandstacks.com/cable-shelf-brackets.
So, to get this going I needed measurements:
Width of the projector, and of the opening the shelf was going into Depth of the projector, including space for cables Weight of the projector (minimal – under 8lbs) Optimal height for the projector
The expensive part was the glass. You could do wood with the kit but I like the look of glass. I needed something deeper than most pre-made glass shelves, so I got this and got a custom glass piece cut. That came out just over $50 for the 15" by 22" cut since I got 1/2" glass. I suggest calling them first and getting quotes (and maybe even seeing if they sell the cable kit too). I think the spacers provided with the cable package would make 3/8" glass fit snugly in the brackets.
If you found a different kit that handled 3/16", you'd find places online that would ship the glass. With the 3/8" and 1/2" sizes the weight makes the shipping cost prohibitive and you are best off buying local. I researched the load that each thickness could carry with the width of the support cables, and all of them could handle well over the weight of the projector.
Installation was pretty simple with a drill and screwdriver (plus pencil and measuring tape of course).
![]() |
| The freshly installed glass shelf |
![]() |
| The initial placement - success! |
Soon after I installed the shelf, I put an entertainment center to fill the space below which helped with storage quite a bit.


No comments:
Post a Comment